How to Use Your Original CoreRelief™ 3-in-1 At-Home Back Therapy

Thanks for choosing CoreRelief™! Here you'll find step-by-step instructions, troubleshooting tips, and important information to get the best results from your device.



Quick Start Guide

Follow these steps to power on your device, switch modes, and get the most from each session.

Red = Heating / Auto power light Blue = Manual mode / Vibration Green = Power ready / Traction lifting
1

Connect to Power

Plug the massager into the included wall adapter. The device must remain plugged in to operate. When connected, the lights will briefly flash red, blue, and green, then turn off. The green light on the power port means the massager is ready.

2

Power On (Automatic Mode)

Hold the power button for 3-5 seconds until the red light turns on. The massager will automatically cycle through its built-in therapy sequence.

  • Vibration
  • Heating
  • Traction lifting
3

Switch to Manual Mode

Hold the manual button (hand icon) for 3-5 seconds. The blue light will turn on, confirming that manual mode is active.

4

Select Manual Functions

Press the manual button again to toggle between the individual therapy modes below.

  • Vibration Massage
  • Traction Lifting
  • Heating
5

Turn Off

Hold either button for 3-5 seconds to power off. The device will also shut off automatically after 30 minutes.

Tip: If the device does not start, make sure it is properly connected to power and remember to hold the button for a full 3-5 seconds rather than pressing it quickly.